root/drivers/media/dvb-frontends/tda1004x.h

/* [<][>][^][v][top][bottom][index][help] */

INCLUDED FROM


DEFINITIONS

This source file includes following definitions.
  1. tda10045_attach
  2. tda10046_attach
  3. tda1004x_writereg

   1 /* SPDX-License-Identifier: GPL-2.0-or-later */
   2   /*
   3      Driver for Philips tda1004xh OFDM Frontend
   4 
   5      (c) 2004 Andrew de Quincey
   6 
   7 
   8    */
   9 
  10 #ifndef TDA1004X_H
  11 #define TDA1004X_H
  12 
  13 #include <linux/dvb/frontend.h>
  14 #include <linux/firmware.h>
  15 
  16 enum tda10046_xtal {
  17         TDA10046_XTAL_4M,
  18         TDA10046_XTAL_16M,
  19 };
  20 
  21 enum tda10046_agc {
  22         TDA10046_AGC_DEFAULT,           /* original configuration */
  23         TDA10046_AGC_IFO_AUTO_NEG,      /* IF AGC only, automatic, negative */
  24         TDA10046_AGC_IFO_AUTO_POS,      /* IF AGC only, automatic, positive */
  25         TDA10046_AGC_TDA827X,           /* IF AGC only, special setup for tda827x */
  26 };
  27 
  28 /* Many (hybrid) boards use GPIO 1 and 3
  29         GPIO1   analog - dvb switch
  30         GPIO3   firmware eeprom address switch
  31 */
  32 enum tda10046_gpio {
  33         TDA10046_GPTRI  = 0x00,         /* All GPIOs tristate */
  34         TDA10046_GP00   = 0x40,         /* GPIO3=0, GPIO1=0 */
  35         TDA10046_GP01   = 0x42,         /* GPIO3=0, GPIO1=1 */
  36         TDA10046_GP10   = 0x48,         /* GPIO3=1, GPIO1=0 */
  37         TDA10046_GP11   = 0x4a,         /* GPIO3=1, GPIO1=1 */
  38         TDA10046_GP00_I = 0x80,         /* GPIO3=0, GPIO1=0, invert in sleep mode*/
  39         TDA10046_GP01_I = 0x82,         /* GPIO3=0, GPIO1=1, invert in sleep mode */
  40         TDA10046_GP10_I = 0x88,         /* GPIO3=1, GPIO1=0, invert in sleep mode */
  41         TDA10046_GP11_I = 0x8a,         /* GPIO3=1, GPIO1=1, invert in sleep mode */
  42 };
  43 
  44 enum tda10046_if {
  45         TDA10046_FREQ_3617,             /* original config, 36,166 MHZ */
  46         TDA10046_FREQ_3613,             /* 36,13 MHZ */
  47         TDA10046_FREQ_045,              /* low IF, 4.0, 4.5, or 5.0 MHZ */
  48         TDA10046_FREQ_052,              /* low IF, 5.1667 MHZ for tda9889 */
  49 };
  50 
  51 enum tda10046_tsout {
  52         TDA10046_TS_PARALLEL  = 0x00,   /* parallel transport stream, default */
  53         TDA10046_TS_SERIAL    = 0x01,   /* serial transport stream */
  54 };
  55 
  56 struct tda1004x_config
  57 {
  58         /* the demodulator's i2c address */
  59         u8 demod_address;
  60 
  61         /* does the "inversion" need inverted? */
  62         u8 invert;
  63 
  64         /* Does the OCLK signal need inverted? */
  65         u8 invert_oclk;
  66 
  67         /* parallel or serial transport stream */
  68         enum tda10046_tsout ts_mode;
  69 
  70         /* Xtal frequency, 4 or 16MHz*/
  71         enum tda10046_xtal xtal_freq;
  72 
  73         /* IF frequency */
  74         enum tda10046_if if_freq;
  75 
  76         /* AGC configuration */
  77         enum tda10046_agc agc_config;
  78 
  79         /* setting of GPIO1 and 3 */
  80         enum tda10046_gpio gpio_config;
  81 
  82         /* slave address and configuration of the tuner */
  83         u8 tuner_address;
  84         u8 antenna_switch;
  85 
  86         /* if the board uses another I2c Bridge (tda8290), its address */
  87         u8 i2c_gate;
  88 
  89         /* request firmware for device */
  90         int (*request_firmware)(struct dvb_frontend* fe, const struct firmware **fw, char* name);
  91 };
  92 
  93 enum tda1004x_demod {
  94         TDA1004X_DEMOD_TDA10045,
  95         TDA1004X_DEMOD_TDA10046,
  96 };
  97 
  98 struct tda1004x_state {
  99         struct i2c_adapter* i2c;
 100         const struct tda1004x_config* config;
 101         struct dvb_frontend frontend;
 102 
 103         /* private demod data */
 104         enum tda1004x_demod demod_type;
 105 };
 106 
 107 #if IS_REACHABLE(CONFIG_DVB_TDA1004X)
 108 extern struct dvb_frontend* tda10045_attach(const struct tda1004x_config* config,
 109                                             struct i2c_adapter* i2c);
 110 
 111 extern struct dvb_frontend* tda10046_attach(const struct tda1004x_config* config,
 112                                             struct i2c_adapter* i2c);
 113 #else
 114 static inline struct dvb_frontend* tda10045_attach(const struct tda1004x_config* config,
 115                                             struct i2c_adapter* i2c)
 116 {
 117         printk(KERN_WARNING "%s: driver disabled by Kconfig\n", __func__);
 118         return NULL;
 119 }
 120 static inline struct dvb_frontend* tda10046_attach(const struct tda1004x_config* config,
 121                                             struct i2c_adapter* i2c)
 122 {
 123         printk(KERN_WARNING "%s: driver disabled by Kconfig\n", __func__);
 124         return NULL;
 125 }
 126 #endif // CONFIG_DVB_TDA1004X
 127 
 128 static inline int tda1004x_writereg(struct dvb_frontend *fe, u8 reg, u8 val) {
 129         int r = 0;
 130         u8 buf[] = {reg, val};
 131         if (fe->ops.write)
 132                 r = fe->ops.write(fe, buf, 2);
 133         return r;
 134 }
 135 
 136 #endif // TDA1004X_H

/* [<][>][^][v][top][bottom][index][help] */