drivers/clocksource/timer-atmel-pit.c

/* [<][>][^][v][top][bottom][index][help] */
This source file includes following definitions.
clksrc_to_pit_data
clkevt_to_pit_data
pit_read
pit_write
read_pit_clk
pit_clkevt_shutdown
pit_clkevt_set_periodic
at91sam926x_pit_suspend
at91sam926x_pit_reset
at91sam926x_pit_resume
at91sam926x_pit_interrupt
at91sam926x_pit_dt_init
   1 // SPDX-License-Identifier: GPL-2.0-only
   2 /*
   3  * at91sam926x_time.c - Periodic Interval Timer (PIT) for at91sam926x
   4  *
   5  * Copyright (C) 2005-2006 M. Amine SAYA, ATMEL Rousset, France
   6  * Revision      2005 M. Nicolas Diremdjian, ATMEL Rousset, France
   7  * Converted to ClockSource/ClockEvents by David Brownell.
   8  */
   9 
  10 #define pr_fmt(fmt)     "AT91: PIT: " fmt
  11 
  12 #include <linux/clk.h>
  13 #include <linux/clockchips.h>
  14 #include <linux/interrupt.h>
  15 #include <linux/irq.h>
  16 #include <linux/kernel.h>
  17 #include <linux/of.h>
  18 #include <linux/of_address.h>
  19 #include <linux/of_irq.h>
  20 #include <linux/slab.h>
  21 
  22 #define AT91_PIT_MR             0x00                    /* Mode Register */
  23 #define AT91_PIT_PITIEN                 BIT(25)                 /* Timer Interrupt Enable */
  24 #define AT91_PIT_PITEN                  BIT(24)                 /* Timer Enabled */
  25 #define AT91_PIT_PIV                    GENMASK(19, 0)          /* Periodic Interval Value */
  26 
  27 #define AT91_PIT_SR             0x04                    /* Status Register */
  28 #define AT91_PIT_PITS                   BIT(0)                  /* Timer Status */
  29 
  30 #define AT91_PIT_PIVR           0x08                    /* Periodic Interval Value Register */
  31 #define AT91_PIT_PIIR           0x0c                    /* Periodic Interval Image Register */
  32 #define AT91_PIT_PICNT                  GENMASK(31, 20)         /* Interval Counter */
  33 #define AT91_PIT_CPIV                   GENMASK(19, 0)          /* Inverval Value */
  34 
  35 #define PIT_CPIV(x)     ((x) & AT91_PIT_CPIV)
  36 #define PIT_PICNT(x)    (((x) & AT91_PIT_PICNT) >> 20)
  37 
  38 struct pit_data {
  39         struct clock_event_device       clkevt;
  40         struct clocksource              clksrc;
  41 
  42         void __iomem    *base;
  43         u32             cycle;
  44         u32             cnt;
  45         unsigned int    irq;
  46         struct clk      *mck;
  47 };
  48 
  49 static inline struct pit_data *clksrc_to_pit_data(struct clocksource *clksrc)
  50 {
  51         return container_of(clksrc, struct pit_data, clksrc);
  52 }
  53 
  54 static inline struct pit_data *clkevt_to_pit_data(struct clock_event_device *clkevt)
  55 {
  56         return container_of(clkevt, struct pit_data, clkevt);
  57 }
  58 
  59 static inline unsigned int pit_read(void __iomem *base, unsigned int reg_offset)
  60 {
  61         return readl_relaxed(base + reg_offset);
  62 }
  63 
  64 static inline void pit_write(void __iomem *base, unsigned int reg_offset, unsigned long value)
  65 {
  66         writel_relaxed(value, base + reg_offset);
  67 }
  68 
  69 /*
  70  * Clocksource:  just a monotonic counter of MCK/16 cycles.
  71  * We don't care whether or not PIT irqs are enabled.
  72  */
  73 static u64 read_pit_clk(struct clocksource *cs)
  74 {
  75         struct pit_data *data = clksrc_to_pit_data(cs);
  76         unsigned long flags;
  77         u32 elapsed;
  78         u32 t;
  79 
  80         raw_local_irq_save(flags);
  81         elapsed = data->cnt;
  82         t = pit_read(data->base, AT91_PIT_PIIR);
  83         raw_local_irq_restore(flags);
  84 
  85         elapsed += PIT_PICNT(t) * data->cycle;
  86         elapsed += PIT_CPIV(t);
  87         return elapsed;
  88 }
  89 
  90 static int pit_clkevt_shutdown(struct clock_event_device *dev)
  91 {
  92         struct pit_data *data = clkevt_to_pit_data(dev);
  93 
  94         /* disable irq, leaving the clocksource active */
  95         pit_write(data->base, AT91_PIT_MR, (data->cycle - 1) | AT91_PIT_PITEN);
  96         return 0;
  97 }
  98 
  99 /*
 100  * Clockevent device:  interrupts every 1/HZ (== pit_cycles * MCK/16)
 101  */
 102 static int pit_clkevt_set_periodic(struct clock_event_device *dev)
 103 {
 104         struct pit_data *data = clkevt_to_pit_data(dev);
 105 
 106         /* update clocksource counter */
 107         data->cnt += data->cycle * PIT_PICNT(pit_read(data->base, AT91_PIT_PIVR));
 108         pit_write(data->base, AT91_PIT_MR,
 109                   (data->cycle - 1) | AT91_PIT_PITEN | AT91_PIT_PITIEN);
 110         return 0;
 111 }
 112 
 113 static void at91sam926x_pit_suspend(struct clock_event_device *cedev)
 114 {
 115         struct pit_data *data = clkevt_to_pit_data(cedev);
 116 
 117         /* Disable timer */
 118         pit_write(data->base, AT91_PIT_MR, 0);
 119 }
 120 
 121 static void at91sam926x_pit_reset(struct pit_data *data)
 122 {
 123         /* Disable timer and irqs */
 124         pit_write(data->base, AT91_PIT_MR, 0);
 125 
 126         /* Clear any pending interrupts, wait for PIT to stop counting */
 127         while (PIT_CPIV(pit_read(data->base, AT91_PIT_PIVR)) != 0)
 128                 cpu_relax();
 129 
 130         /* Start PIT but don't enable IRQ */
 131         pit_write(data->base, AT91_PIT_MR,
 132                   (data->cycle - 1) | AT91_PIT_PITEN);
 133 }
 134 
 135 static void at91sam926x_pit_resume(struct clock_event_device *cedev)
 136 {
 137         struct pit_data *data = clkevt_to_pit_data(cedev);
 138 
 139         at91sam926x_pit_reset(data);
 140 }
 141 
 142 /*
 143  * IRQ handler for the timer.
 144  */
 145 static irqreturn_t at91sam926x_pit_interrupt(int irq, void *dev_id)
 146 {
 147         struct pit_data *data = dev_id;
 148 
 149         /* The PIT interrupt may be disabled, and is shared */
 150         if (clockevent_state_periodic(&data->clkevt) &&
 151             (pit_read(data->base, AT91_PIT_SR) & AT91_PIT_PITS)) {
 152                 /* Get number of ticks performed before irq, and ack it */
 153                 data->cnt += data->cycle * PIT_PICNT(pit_read(data->base,
 154                                                               AT91_PIT_PIVR));
 155                 data->clkevt.event_handler(&data->clkevt);
 156 
 157                 return IRQ_HANDLED;
 158         }
 159 
 160         return IRQ_NONE;
 161 }
 162 
 163 /*
 164  * Set up both clocksource and clockevent support.
 165  */
 166 static int __init at91sam926x_pit_dt_init(struct device_node *node)
 167 {
 168         unsigned long   pit_rate;
 169         unsigned        bits;
 170         int             ret;
 171         struct pit_data *data;
 172 
 173         data = kzalloc(sizeof(*data), GFP_KERNEL);
 174         if (!data)
 175                 return -ENOMEM;
 176 
 177         data->base = of_iomap(node, 0);
 178         if (!data->base) {
 179                 pr_err("Could not map PIT address\n");
 180                 ret = -ENXIO;
 181                 goto exit;
 182         }
 183 
 184         data->mck = of_clk_get(node, 0);
 185         if (IS_ERR(data->mck)) {
 186                 pr_err("Unable to get mck clk\n");
 187                 ret = PTR_ERR(data->mck);
 188                 goto exit;
 189         }
 190 
 191         ret = clk_prepare_enable(data->mck);
 192         if (ret) {
 193                 pr_err("Unable to enable mck\n");
 194                 goto exit;
 195         }
 196 
 197         /* Get the interrupts property */
 198         data->irq = irq_of_parse_and_map(node, 0);
 199         if (!data->irq) {
 200                 pr_err("Unable to get IRQ from DT\n");
 201                 ret = -EINVAL;
 202                 goto exit;
 203         }
 204 
 205         /*
 206          * Use our actual MCK to figure out how many MCK/16 ticks per
 207          * 1/HZ period (instead of a compile-time constant LATCH).
 208          */
 209         pit_rate = clk_get_rate(data->mck) / 16;
 210         data->cycle = DIV_ROUND_CLOSEST(pit_rate, HZ);
 211         WARN_ON(((data->cycle - 1) & ~AT91_PIT_PIV) != 0);
 212 
 213         /* Initialize and enable the timer */
 214         at91sam926x_pit_reset(data);
 215 
 216         /*
 217          * Register clocksource.  The high order bits of PIV are unused,
 218          * so this isn't a 32-bit counter unless we get clockevent irqs.
 219          */
 220         bits = 12 /* PICNT */ + ilog2(data->cycle) /* PIV */;
 221         data->clksrc.mask = CLOCKSOURCE_MASK(bits);
 222         data->clksrc.name = "pit";
 223         data->clksrc.rating = 175;
 224         data->clksrc.read = read_pit_clk;
 225         data->clksrc.flags = CLOCK_SOURCE_IS_CONTINUOUS;
 226         
 227         ret = clocksource_register_hz(&data->clksrc, pit_rate);
 228         if (ret) {
 229                 pr_err("Failed to register clocksource\n");
 230                 goto exit;
 231         }
 232 
 233         /* Set up irq handler */
 234         ret = request_irq(data->irq, at91sam926x_pit_interrupt,
 235                           IRQF_SHARED | IRQF_TIMER | IRQF_IRQPOLL,
 236                           "at91_tick", data);
 237         if (ret) {
 238                 pr_err("Unable to setup IRQ\n");
 239                 clocksource_unregister(&data->clksrc);
 240                 goto exit;
 241         }
 242 
 243         /* Set up and register clockevents */
 244         data->clkevt.name = "pit";
 245         data->clkevt.features = CLOCK_EVT_FEAT_PERIODIC;
 246         data->clkevt.shift = 32;
 247         data->clkevt.mult = div_sc(pit_rate, NSEC_PER_SEC, data->clkevt.shift);
 248         data->clkevt.rating = 100;
 249         data->clkevt.cpumask = cpumask_of(0);
 250 
 251         data->clkevt.set_state_shutdown = pit_clkevt_shutdown;
 252         data->clkevt.set_state_periodic = pit_clkevt_set_periodic;
 253         data->clkevt.resume = at91sam926x_pit_resume;
 254         data->clkevt.suspend = at91sam926x_pit_suspend;
 255         clockevents_register_device(&data->clkevt);
 256 
 257         return 0;
 258 
 259 exit:
 260         kfree(data);
 261         return ret;
 262 }
 263 TIMER_OF_DECLARE(at91sam926x_pit, "atmel,at91sam9260-pit",
 264                        at91sam926x_pit_dt_init);
/* [<][>][^][v][top][bottom][index][help] */
root/drivers/clocksource/timer-atmel-pit.c

DEFINITIONS
