drivers/input/serio/olpc

/* [<][>][^][v][top][bottom][index][help] */
This source file includes following definitions.
olpc_apsp_write
olpc_apsp_rx
olpc_apsp_open
olpc_apsp_close
olpc_apsp_probe
olpc_apsp_remove
   1 // SPDX-License-Identifier: GPL-2.0-or-later
   2 /*
   3  * OLPC serio driver for multiplexed input from Marvell MMP security processor
   4  *
   5  * Copyright (C) 2011-2013 One Laptop Per Child
   6  */
   7 
   8 #include <linux/module.h>
   9 #include <linux/interrupt.h>
  10 #include <linux/serio.h>
  11 #include <linux/err.h>
  12 #include <linux/platform_device.h>
  13 #include <linux/io.h>
  14 #include <linux/of.h>
  15 #include <linux/slab.h>
  16 #include <linux/delay.h>
  17 
  18 /*
  19  * The OLPC XO-1.75 and XO-4 laptops do not have a hardware PS/2 controller.
  20  * Instead, the OLPC firmware runs a bit-banging PS/2 implementation on an
  21  * otherwise-unused slow processor which is included in the Marvell MMP2/MMP3
  22  * SoC, known as the "Security Processor" (SP) or "Wireless Trusted Module"
  23  * (WTM). This firmware then reports its results via the WTM registers,
  24  * which we read from the Application Processor (AP, i.e. main CPU) in this
  25  * driver.
  26  *
  27  * On the hardware side we have a PS/2 mouse and an AT keyboard, the data
  28  * is multiplexed through this system. We create a serio port for each one,
  29  * and demultiplex the data accordingly.
  30  */
  31 
  32 /* WTM register offsets */
  33 #define SECURE_PROCESSOR_COMMAND        0x40
  34 #define COMMAND_RETURN_STATUS           0x80
  35 #define COMMAND_FIFO_STATUS             0xc4
  36 #define PJ_RST_INTERRUPT                0xc8
  37 #define PJ_INTERRUPT_MASK               0xcc
  38 
  39 /*
  40  * The upper byte of SECURE_PROCESSOR_COMMAND and COMMAND_RETURN_STATUS is
  41  * used to identify which port (device) is being talked to. The lower byte
  42  * is the data being sent/received.
  43  */
  44 #define PORT_MASK       0xff00
  45 #define DATA_MASK       0x00ff
  46 #define PORT_SHIFT      8
  47 #define KEYBOARD_PORT   0
  48 #define TOUCHPAD_PORT   1
  49 
  50 /* COMMAND_FIFO_STATUS */
  51 #define CMD_CNTR_MASK           0x7 /* Number of pending/unprocessed commands */
  52 #define MAX_PENDING_CMDS        4   /* from device specs */
  53 
  54 /* PJ_RST_INTERRUPT */
  55 #define SP_COMMAND_COMPLETE_RESET       0x1
  56 
  57 /* PJ_INTERRUPT_MASK */
  58 #define INT_0   (1 << 0)
  59 
  60 /* COMMAND_FIFO_STATUS */
  61 #define CMD_STS_MASK    0x100
  62 
  63 struct olpc_apsp {
  64         struct device *dev;
  65         struct serio *kbio;
  66         struct serio *padio;
  67         void __iomem *base;
  68         int open_count;
  69         int irq;
  70 };
  71 
  72 static int olpc_apsp_write(struct serio *port, unsigned char val)
  73 {
  74         struct olpc_apsp *priv = port->port_data;
  75         unsigned int i;
  76         u32 which = 0;
  77 
  78         if (port == priv->padio)
  79                 which = TOUCHPAD_PORT << PORT_SHIFT;
  80         else
  81                 which = KEYBOARD_PORT << PORT_SHIFT;
  82 
  83         dev_dbg(priv->dev, "olpc_apsp_write which=%x val=%x\n", which, val);
  84         for (i = 0; i < 50; i++) {
  85                 u32 sts = readl(priv->base + COMMAND_FIFO_STATUS);
  86                 if ((sts & CMD_CNTR_MASK) < MAX_PENDING_CMDS) {
  87                         writel(which | val,
  88                                priv->base + SECURE_PROCESSOR_COMMAND);
  89                         return 0;
  90                 }
  91                 /* SP busy. This has not been seen in practice. */
  92                 mdelay(1);
  93         }
  94 
  95         dev_dbg(priv->dev, "olpc_apsp_write timeout, status=%x\n",
  96                 readl(priv->base + COMMAND_FIFO_STATUS));
  97 
  98         return -ETIMEDOUT;
  99 }
 100 
 101 static irqreturn_t olpc_apsp_rx(int irq, void *dev_id)
 102 {
 103         struct olpc_apsp *priv = dev_id;
 104         unsigned int w, tmp;
 105         struct serio *serio;
 106 
 107         /*
 108          * Write 1 to PJ_RST_INTERRUPT to acknowledge and clear the interrupt
 109          * Write 0xff00 to SECURE_PROCESSOR_COMMAND.
 110          */
 111         tmp = readl(priv->base + PJ_RST_INTERRUPT);
 112         if (!(tmp & SP_COMMAND_COMPLETE_RESET)) {
 113                 dev_warn(priv->dev, "spurious interrupt?\n");
 114                 return IRQ_NONE;
 115         }
 116 
 117         w = readl(priv->base + COMMAND_RETURN_STATUS);
 118         dev_dbg(priv->dev, "olpc_apsp_rx %x\n", w);
 119 
 120         if (w >> PORT_SHIFT == KEYBOARD_PORT)
 121                 serio = priv->kbio;
 122         else
 123                 serio = priv->padio;
 124 
 125         serio_interrupt(serio, w & DATA_MASK, 0);
 126 
 127         /* Ack and clear interrupt */
 128         writel(tmp | SP_COMMAND_COMPLETE_RESET, priv->base + PJ_RST_INTERRUPT);
 129         writel(PORT_MASK, priv->base + SECURE_PROCESSOR_COMMAND);
 130 
 131         pm_wakeup_event(priv->dev, 1000);
 132         return IRQ_HANDLED;
 133 }
 134 
 135 static int olpc_apsp_open(struct serio *port)
 136 {
 137         struct olpc_apsp *priv = port->port_data;
 138         unsigned int tmp;
 139         unsigned long l;
 140 
 141         if (priv->open_count++ == 0) {
 142                 l = readl(priv->base + COMMAND_FIFO_STATUS);
 143                 if (!(l & CMD_STS_MASK)) {
 144                         dev_err(priv->dev, "SP cannot accept commands.\n");
 145                         return -EIO;
 146                 }
 147 
 148                 /* Enable interrupt 0 by clearing its bit */
 149                 tmp = readl(priv->base + PJ_INTERRUPT_MASK);
 150                 writel(tmp & ~INT_0, priv->base + PJ_INTERRUPT_MASK);
 151         }
 152 
 153         return 0;
 154 }
 155 
 156 static void olpc_apsp_close(struct serio *port)
 157 {
 158         struct olpc_apsp *priv = port->port_data;
 159         unsigned int tmp;
 160 
 161         if (--priv->open_count == 0) {
 162                 /* Disable interrupt 0 */
 163                 tmp = readl(priv->base + PJ_INTERRUPT_MASK);
 164                 writel(tmp | INT_0, priv->base + PJ_INTERRUPT_MASK);
 165         }
 166 }
 167 
 168 static int olpc_apsp_probe(struct platform_device *pdev)
 169 {
 170         struct serio *kb_serio, *pad_serio;
 171         struct olpc_apsp *priv;
 172         struct resource *res;
 173         int error;
 174 
 175         priv = devm_kzalloc(&pdev->dev, sizeof(struct olpc_apsp), GFP_KERNEL);
 176         if (!priv)
 177                 return -ENOMEM;
 178 
 179         priv->dev = &pdev->dev;
 180 
 181         res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
 182         priv->base = devm_ioremap_resource(&pdev->dev, res);
 183         if (IS_ERR(priv->base)) {
 184                 dev_err(&pdev->dev, "Failed to map WTM registers\n");
 185                 return PTR_ERR(priv->base);
 186         }
 187 
 188         priv->irq = platform_get_irq(pdev, 0);
 189         if (priv->irq < 0)
 190                 return priv->irq;
 191 
 192         /* KEYBOARD */
 193         kb_serio = kzalloc(sizeof(struct serio), GFP_KERNEL);
 194         if (!kb_serio)
 195                 return -ENOMEM;
 196         kb_serio->id.type       = SERIO_8042_XL;
 197         kb_serio->write         = olpc_apsp_write;
 198         kb_serio->open          = olpc_apsp_open;
 199         kb_serio->close         = olpc_apsp_close;
 200         kb_serio->port_data     = priv;
 201         kb_serio->dev.parent    = &pdev->dev;
 202         strlcpy(kb_serio->name, "sp keyboard", sizeof(kb_serio->name));
 203         strlcpy(kb_serio->phys, "sp/serio0", sizeof(kb_serio->phys));
 204         priv->kbio              = kb_serio;
 205         serio_register_port(kb_serio);
 206 
 207         /* TOUCHPAD */
 208         pad_serio = kzalloc(sizeof(struct serio), GFP_KERNEL);
 209         if (!pad_serio) {
 210                 error = -ENOMEM;
 211                 goto err_pad;
 212         }
 213         pad_serio->id.type      = SERIO_8042;
 214         pad_serio->write        = olpc_apsp_write;
 215         pad_serio->open         = olpc_apsp_open;
 216         pad_serio->close        = olpc_apsp_close;
 217         pad_serio->port_data    = priv;
 218         pad_serio->dev.parent   = &pdev->dev;
 219         strlcpy(pad_serio->name, "sp touchpad", sizeof(pad_serio->name));
 220         strlcpy(pad_serio->phys, "sp/serio1", sizeof(pad_serio->phys));
 221         priv->padio             = pad_serio;
 222         serio_register_port(pad_serio);
 223 
 224         error = request_irq(priv->irq, olpc_apsp_rx, 0, "olpc-apsp", priv);
 225         if (error) {
 226                 dev_err(&pdev->dev, "Failed to request IRQ\n");
 227                 goto err_irq;
 228         }
 229 
 230         device_init_wakeup(priv->dev, 1);
 231         platform_set_drvdata(pdev, priv);
 232 
 233         dev_dbg(&pdev->dev, "probed successfully.\n");
 234         return 0;
 235 
 236 err_irq:
 237         serio_unregister_port(pad_serio);
 238 err_pad:
 239         serio_unregister_port(kb_serio);
 240         return error;
 241 }
 242 
 243 static int olpc_apsp_remove(struct platform_device *pdev)
 244 {
 245         struct olpc_apsp *priv = platform_get_drvdata(pdev);
 246 
 247         free_irq(priv->irq, priv);
 248 
 249         serio_unregister_port(priv->kbio);
 250         serio_unregister_port(priv->padio);
 251 
 252         return 0;
 253 }
 254 
 255 static const struct of_device_id olpc_apsp_dt_ids[] = {
 256         { .compatible = "olpc,ap-sp", },
 257         {}
 258 };
 259 MODULE_DEVICE_TABLE(of, olpc_apsp_dt_ids);
 260 
 261 static struct platform_driver olpc_apsp_driver = {
 262         .probe          = olpc_apsp_probe,
 263         .remove         = olpc_apsp_remove,
 264         .driver         = {
 265                 .name   = "olpc-apsp",
 266                 .of_match_table = olpc_apsp_dt_ids,
 267         },
 268 };
 269 
 270 MODULE_DESCRIPTION("OLPC AP-SP serio driver");
 271 MODULE_LICENSE("GPL");
 272 module_platform_driver(olpc_apsp_driver);
/* [<][>][^][v][top][bottom][index][help] */
root/drivers/input/serio/olpc_apsp.c

DEFINITIONS
