[ 4623.203190] usb 9-1: new SuperSpeed USB device number 4 using xhci_hcd [ 4623.236862] usb 9-1: New USB device found, idVendor=0b95, idProduct=1790 [ 4623.236875] usb 9-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3 [ 4623.236881] usb 9-1: Product: AX88179 [ 4623.236887] usb 9-1: Manufacturer: ASIX Elec. Corp. [ 4623.236892] usb 9-1: SerialNumber: 000000000092D8 [ 4623.604172] ax88179_178a 9-1:1.0 eth0: register 'ax88179_178a' at usb-0000:03:00.0-1, ASIX AX88179 USB 3.0 Gigabit Ethernet, 58:27:8c:be:67:4e [ 4623.740322] ax88179_178a 9-1:1.0 enx58278cbe674e: renamed from eth0 [ 4623.778144] IPv6: ADDRCONF(NETDEV_UP): enx58278cbe674e: link is not ready [ 4624.132102] IPv6: ADDRCONF(NETDEV_UP): enx58278cbe674e: link is not ready [ 4626.621909] ax88179_178a 9-1:1.0 enx58278cbe674e: ax88179 - Link status is: 1 [ 4626.638384] IPv6: ADDRCONF(NETDEV_CHANGE): enx58278cbe674e: link becomes ready 201010-183322 root@solder:/home/furuta# ifcoifconfig enp2s0: flags=4099 mtu 1500 ether 1c:6f:65:c1:ea:73 txqueuelen 1000 (Ethernet) RX packets 17902 bytes 1667780 (1.6 MB) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 252 bytes 33987 (33.9 KB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 enx58278cbe674e: flags=4163 mtu 1500 inet 192.168.0.36 netmask 255.255.255.0 broadcast 192.168.0.255 inet6 240f:6e:7f7:1:c0f2:9261:aa8c:bd3d prefixlen 64 scopeid 0x0 inet6 240f:6e:7f7:1:d47d:e2da:a649:9eb9 prefixlen 64 scopeid 0x0 inet6 fe80::ca2e:80d2:ac1e:12b9 prefixlen 64 scopeid 0x20 ether 58:27:8c:be:67:4e txqueuelen 1000 (Ethernet) RX packets 987 bytes 78007 (78.0 KB) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 141 bytes 21249 (21.2 KB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 lo: flags=73 mtu 65536 inet 127.0.0.1 netmask 255.0.0.0 inet6 ::1 prefixlen 128 scopeid 0x10 loop txqueuelen 1000 (Local Loopback) RX packets 1616 bytes 542036 (542.0 KB) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 1616 bytes 542036 (542.0 KB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 virbr0: flags=4099 mtu 1500 inet 192.168.122.1 netmask 255.255.255.0 broadcast 192.168.122.255 ether 52:54:00:2a:31:53 txqueuelen 1000 (Ethernet) RX packets 0 bytes 0 (0.0 B) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 0 bytes 0 (0.0 B) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 201010-183345 root@solder:/home/furuta# ethtool enx58278cbe674e Settings for enx58278cbe674e: Supported ports: [ TP MII ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Half 1000baseT/Full Supported pause frame use: No Supports auto-negotiation: Yes Supported FEC modes: Not reported Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Advertised pause frame use: Symmetric Advertised auto-negotiation: Yes Advertised FEC modes: Not reported Link partner advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Link partner advertised pause frame use: Symmetric Link partner advertised auto-negotiation: Yes Link partner advertised FEC modes: Not reported Speed: 1000Mb/s Duplex: Full Port: MII PHYAD: 3 Transceiver: internal Auto-negotiation: on Supports Wake-on: pg Wake-on: g Current message level: 0x00000007 (7) drv probe link Link detected: yes