Lines Matching refs:as

44        time as ARM-compatible hardware is available, and the specification
85        conditions; it allows one to inject an error into the system as
119        If PSCI is used (as is recommended), make sure that ARM_BOOT_ARCH is
121        PSCI_USE_HVC is set or unset as needed (see table 5-37).
158        x86 only table as of ACPI 5.1; future versions have been adapted for
281 _ADR   6.1.1           Use as needed.
283 _BBN   6.5.5           Use as needed; PCI-specific.
289                        it explicit ensures the kernel will set up DMA as
294 _CID   6.1.2           Use as needed.
296 _CLS   6.1.3           Use as needed.
306 _DEP   6.5.8           Use as needed.
325                        with the UEFI Forum; this may cause some iteration as
332 _DSW   7.2.1           Use as needed; power management specific.
354 _HID   6.1.5           Use as needed.  This is the primary object to use in
361 _HRV   6.1.6           Optional, use as needed to clarify device behavior; in
368 _IRC   7.2.15          Use as needed; power management specific.
391                        as a global method, only capabilities published in
392                        the ACPI specification are allowed.  When used as
396                        submit the device-specific _OSC usage description as
403                        That is, as far as ACPI firmware is concerned, _OSI
422 _PRT   6.2.13          Required as part of the definition of all PCI root
425 _PRW   7.2.13          Use as needed; power management specific.
427 _PRx   7.2.8-11        Use as needed; power management specific.  If _PR0 is
430 _PSC   7.2.6           Use as needed; power management specific.
432 _PSE   7.2.7           Use as needed; power management specific.
434 _PSW   7.2.14          Use as needed; power management specific.
436 _PSx   7.2.2-5         Use as needed; power management specific.  If _PS0 is
441 \_PTS  7.3.1           Use as needed; power management specific.
445 _REG   6.5.4           Use as needed.
454 _SEG   6.5.6           Use as needed; PCI-specific.
469 _SUB   6.1.9           Use as needed; _HID or _CID are preferred.
473 \_Sx   7.3.2           Use as needed; power management specific.
475 _SxD   7.2.16-19       Use as needed; power management specific.
477 _SxW   7.2.20-24       Use as needed; power management specific.
479 _SWS   7.3.3           Use as needed; power management specific; this may
482 \_TTS  7.3.4           Use as needed; power management specific.
489 \_WAK  7.3.5           Use as needed; power management specific.
508 recommended that CPPC (8.4.5) be used as the primary model.  This will
521 In Section 15 of the ACPI specification, several methods are mentioned as
538 these slightly differently.  The SCI is handled as a normal GPIO-signaled
540 reported, this is sufficient.  The NMI is emulated as the highest priority
543 at the same priority as the emulated NMI.  In Linux, this should not be the