Lines Matching refs:zone

38 			 the IC. See thermal zone binding for more details
105 get assigned to trip points of the zone. The cooling devices are expected
115   Type: phandle of	zone.
119 - contribution:		The cooling contribution to the thermal zone of the
122 			of all cooling contributions within a thermal zone.
130 * Thermal zone nodes
132 The thermal zone node is the node containing all the required info
133 for describing a thermal zone, including its cooling device bindings. The
134 thermal zone node must contain, apart from its own properties, one sub-node
135 containing trip nodes and one sub-node containing all the zone cooling maps.
139   Type: unsigned	when checking this thermal zone.
147   Type: list of 	used while monitoring the thermal zone.
152   Type: sub-node	required to describe the thermal zone.
171 derivative over time) in two situations for a thermal zone:
173 (ii) - when the zone just needs to be monitored (polling-delay) or
185 The "thermal-zones" node is a container for all thermal zone nodes. It shall
187 "Thermal zone nodes". The "thermal-zones" node appears under "/".
194 (a) - CPU thermal zone
196 The CPU thermal zone example below describes how to setup one thermal zone
297 used to monitor the zone 'cpu-thermal' using its sole sensor. A fan
300 the thermal zone 'cpu-thermal' using its cooling states
304 linked to the same thermal zone, 'cpu-thermal', as a passive cooling device,
306 which is a trip point at 100C. On the thermal zone 'cpu-thermal', at the
340 			/* each zone within the SoC may have its own trips */
354 			/* each zone within the SoC may have its own cooling */
367 			/* each zone within the SoC may have its own trips */
381 			/* each zone within the SoC may have its own cooling */
394 			/* each zone within the SoC may have its own trips */
408 			/* each zone within the SoC may have its own cooling */
417 hotspots: one for CPU thermal zone, one for GPU thermal zone and the
418 other to monitor a DSP thermal zone.
424 monitor CPU thermal zone, <bandgap 1> is used to monitor GPU thermal
425 zone and <bandgap 2> is used to monitor DSP thermal zone. Each zone
430 (c) - Several sensors within one single thermal zone
433 one thermal zone.
501 The board thermal example below illustrates how to setup one thermal zone