Lines Matching refs:drive

36 	HDIO_DRIVE_TASK		execute task and special drive command
37 	HDIO_DRIVE_CMD		execute a special drive command
106 	  EINVAL	if the device is not a disk drive or floppy drive,
115 	  drive geometry is an abstraction which is actually subject
117 	  are the "bios" values -- presumably the values the drive had
141 	  The value of the drive's current unmask setting
177 	  controls how many sectors the drive will transfer per
191 	  sectors the drive will transfer per interrupt.
230 	returns the first 142 bytes of drive identity information.
245 	  ATA drive identity information.  For full description, see
255 	  Returns information that was obtained when the drive was
257 	  this ioctl does not re-probe the drive to update the
279 	  after a drive reset.
360 	  The drive's "nice" values.
364 	  Per-drive flags which determine when the system will give more
387 	  EPERM		DSC_OVERLAP specified but not supported by drive
530 	registers of the drive.  Requires ADMIN and RAWIO access
572 	  ENOMSG	Device is not a disk drive.
575 	  EPERM		req_cmd == TASKFILE_MULTI_OUT and drive
594 	     if LBA48 addressing is enabled for the drive
612 	  drive, followed by an optional buffer to receive data from
613 	  the drive.
615 	  Command is passed to the disk drive via the ide_task_request_t
629 	    out_size		output (user->drive) buffer size, bytes
630 	    in_size		input (drive->user) buffer size, bytes
634 	    HOB_FEATURE		If the drive supports LBA48
635 	    HOB_NSECTOR		If the drive supports LBA48
636 	    HOB_SECTOR		If the drive supports LBA48
637 	    HOB_LCYL		If the drive supports LBA48
638 	    HOB_HCYL		If the drive supports LBA48
668 	  Taskfile registers are read back from the drive into
673 	    1. The drive fails the command (EIO).
683 	    HOB_FEATURE		If the drive supports LBA48
684 	    HOB_NSECTOR		If the drive supports LBA48
685 	    HOB_SECTOR		If the drive supports LBA48
686 	    HOB_LCYL		If the drive supports LBA48
687 	    HOB_HCYL		If the drive supports LBA48
729 HDIO_DRIVE_CMD			execute a special drive command
775 	  value for the drive.  Please refer to HDIO_DRIVE_TASKFILE
778 	  [2] If NSECTOR value is greater than zero and the drive sets
786 	  && NSECTOR >= XFER_SW_DMA_0 && the drive supports any DMA
788 	  drive accordingly.
792 HDIO_DRIVE_TASK			execute task and special drive command
828 	  ENOMSG	Device is not a disk drive.
834 	  appropriate value for the drive is used.  All other bits
973 	  Currently (2.6.8) this ioctl silently fails if any drive on
1006 	  New value for drive acoustic settings