Lines Matching refs:scanning
42 Memory scanning parameters can be modified at run-time by writing to the
46 stack=on - enable the task stacks scanning (default)
47 stack=off - disable the tasks stacks scanning
48 scan=on - start the automatic memory scanning thread (default)
49 scan=off - stop the automatic memory scanning thread
50 scan=<secs> - set the automatic memory scanning period in seconds
51 (default 600, 0 to stop the automatic scanning)
80 scanning the memory (including saved registers). This means that there
85 The scanning algorithm steps:
162 reported by kmemleak because values found during the memory scanning
166 amount of false negatives and their scanning is not enabled by default.
183 freeing. To avoid other penalties, the memory scanning is only performed