Lines Matching refs:video

305 4.1) video=
308 Syntax: video=<fbname>:<sub-options...>
316     `video' during the development of the 1.3.x kernels, thus you
320 NBB: The behavior of video= was changed in 2.1.57 so the recommended
326 This sub-option may be any of the predefined video modes, as listed
328 activate the given video mode at boot time and make it the default
344   If no video mode is given on the command line, the kernel tries the
348   A video mode setting doesn't make sense, if the external driver is
373 The number of additional lines of video memory to reserve for
375 is possible only if the kernel can set the video base address in steps
382 display. Thus, the amount of video memory is doubled, compared to no
391 This option specifies the capabilities of some extended internal video
401   Often, extended interval video hardware has to be activated somehow.
414 you have some external video hardware (a graphics board), and how to
417 video modes, since it doesn't know about any board internal. So, you
418 have to switch to that video mode before you start Linux, and cannot
427   You have to tell the kernel furthermore how the video memory is
433 	  built-in Atari video modes, I think there is no card that
447   The next important information about the video hardware is the base
448 address of the video memory. That is given in the <scrmem> parameter,
453 video memory. If it's missing, the size is calculated from <xres>,
456 with the external driver, because the kernel cannot set the video base
459 empty, either by ending the "external:" after the video address or by
464 cannot read or write any color registers of the video hardware, and
488 initialisation of the video-card.
519 If this option is given, the framebuffer device doesn't do any video
523   What you reach with this: Settings for unknown video extensions
526 But this also means, that you can't switch video modes anymore...
659 video extension. The difference to the bare option is that the
660 switch-on is done after video initialization, and somehow synchronized
672 5.1) video=
675 Syntax: video=<fbname>:<sub-options...>
686 "video"-option (4.1), but knows fewer sub-options.
688 5.1.1) video mode
691 Again, similar to the video mode for the Atari (see 4.1.1). Predefined
695 predefined video modes are available:
731 Specify the number of bit-planes for the selected video-mode.