Lines Matching refs:Duplex
12 - Speed and Duplex Configuration
36 NOTES: For more information about the AutoNeg, Duplex, and Speed
37 parameters, see the "Speed and Duplex Configuration" section in
53 Duplex parameters must not be specified.
55 NOTE: Refer to the Speed and Duplex section of this readme for more
58 Duplex
65 either one or two-directional. If both Duplex and the link partner are
67 link partner is forced (either full or half), Duplex defaults to half-
229 speed. Duplex should also be set when Speed is set to either 10 or 100.
339 Speed and Duplex Configuration
343 These keywords are Speed, Duplex, and AutoNeg.
357 If Speed = 10 or 100, then both Speed and Duplex should be set. Auto-
373 Duplex Full Full Half Full Half
387 Note that when this parameter is used, Speed and Duplex must not be specified.
390 parameter should not be used. Instead, use the Speed and Duplex parameters