Lines Matching refs:as

9 configuration dialog.  You can also compile it as a module.
18 as the following to your /etc/lilo.conf:
26 If you load the driver as a module, you can pass the parameters "io=",
28 them as options in a configuration file in /etc/modprobe.d/ directory:
34 need to add a line such as:
55 compiled as a module, you will need to refer to it as "dummy0" or some
69 board.  Set the switches so as not to conflict with other hardware.
101 Instead, you follow the same procedure as for doing IP in EtherTalk.
110 this, either compile the driver as a module, or pass the parameters
111 for the card to the kernel as described above.
113 Also, as usual, autoprobing is not recommended when you use the driver
114 as a module. (though it usually works at boot time, at least)