Lines Matching refs:you

3 In order to use it, you will need at least version 1.3.3 of the
13 this reason, you should be prepared to supply these parameters
17 When the driver is compiled into the kernel, you can add a line such
26 If you load the driver as a module, you can pass the parameters "io=",
33 Before starting up the netatalk demons (perhaps in rc.local), you
41 The appropriate netatalk configuration depends on whether you are
43 like me, you are simply connecting to your home Macintoshes and
44 printers, you need to set up netatalk to "seed".  The way I do this
54 sure you have the correct name for the dummy interface - If it's
55 compiled as a module, you will need to refer to it as "dummy0" or some
58 If you are attached to an extended AppleTalk network, with routers on
59 it, then you don't need to fool around with this -- the appropriate
73        original documentation refers to IRQ2.  Since you'll be running
97 Yes, it is possible to do IP over LocalTalk.  However, you can't just
101 Instead, you follow the same procedure as for doing IP in EtherTalk.
113 Also, as usual, autoprobing is not recommended when you use the driver
120 machine, but this is unsupported, so if you really want to do this,
121 you'll probably have to hack the initialization code a bit.