Lines Matching refs:with

12 The parport code is split into two parts: generic (which deals with
13 port-sharing) and architecture-dependent (which deals with actually
25 architecture-dependent code with (for example):
30 0x3bc with no IRQ, one at 0x378 using IRQ 7, and one at 0x278 with an
48 modprobe will load parport_pc (with the options "io=0x378,0x278 irq=7,auto")
61 enhanced and now lives with the IEEE 1284 support.  When a parallel
143 		with tabs.  These values might not have any sensible
206 with no lp device associated with the second port (parport1).  Note
219  * If you give PLIP the `timid' parameter, either with `plip=timid' on
220    the command line, or with `insmod plip timid=1' when using modules,
225 Reporting printer problems with parport
231 When reporting problems with parport, really you need to give all of
251 So, to start with, disable CONFIG_PARPORT_PC_FIFO, and load parport_pc
252 with 'irq=none'. See if printing works then.  It really should,
255 If that works fine, try with 'io=0x378 irq=7' (adjust for your
261 the DMA channel, and try with: