Lines Matching refs:used
27 continued using existing format, and the default format is used if
32 used only in variable block mode (I don't know if this is sensible
44 the configuration of mode 0 is used to provide a starting point for
53 If more than one mode is used, all modes should contain definitions
92 consecutive files must be written fast. The MTWEOFI operation can be used to
95 operation is MTWEOFI, close() does not write a filemark. This can be used if
104 4. If the open option O_NONBLOCK is used, open succeeds even if the
105 drive is not ready. If O_NONBLOCK is not used, the driver waits for
116 each drive are used.
125 backward compatible with the numbering used when the minor number was
147 bit definitions are the same as those used with MTSETDRVBUFFER in setting the
168 is not possible, a driver buffer allocated at run-time is used. If
170 is used (i.e., bounce buffers for individual pages are not
171 used). Direct i/o can be impossible because of several reasons, e.g.:
183 allowed if ST_BUFFER_WRITES is non-zero and direct i/o is not used.
188 NOTE that if direct i/o is used, the small writes are not buffered. This may
209 in the physical memory) are used if contiguous buffers can't be
213 1. The initial segment that is used for all SCSI adapters including
222 allocated so that as many segments as possible are used but the number
225 max_sg_segs) and the number of segments used in phases 1 and 2
226 are used to extend the buffer at run-time if this is necessary. The
230 is smaller than the number of segments used in phases 1 and 2,
266 to use the same keyword used when loading as module but prepended
268 segments, the parameter 'st.max_sg_segs=xx' should be used (xx is the
272 versions is supported. The same keywords can be used as when loading
275 used instead of the equal mark. The definition is prepended by the
280 The following syntax used by the old kernel versions is also supported:
322 is used. The long erase command is used with all other values
334 MT_ST_HPLOADER_OFFSET + 6, the number x is used sent to the
357 Is used for several purposes. The command is obtained from count
358 with mask MT_SET_OPTIONS, the low order bits are used as argument.
377 be used for repositioning the tape (global)
383 MT_ST_SCSI2LOGICAL the logical block number is used in
410 0xffffff means that the default is not used any more.
415 (0xfffff) the default will not be used any more. Otherwise
419 The compression default will not be used if the value of
423 used as the compression algorithm. The value
424 MT_ST_CLEAR_DEFAULT can be used to clear the compression
432 Set the long timeout that is used for operations that are