Lines Matching refs:all
28 8.7 Reset all logical units of a target
29 8.8 Abort all tasks of all logical units of a target
114 The following features are supported for all chips:
250 - target 2 all luns on controller 0 --> 15
251 - target 3 all luns on controller 0 --> 15
252 - target 4 all luns on controller 0 --> 7
254 - all other target/lun --> 4
302 Using "all" for "<target>" parameter with the commands below will
303 apply to all targets of the SCSI chain (except the controller).
369 - setflag all
370 will allow disconnection for all devices on the SCSI bus.
380 8.7 Reset all logical units of a target
387 8.8 Abort all tasks of all logical units of a target
392 The driver will try to send a ABORT message to all the logical units
400 If the firmware of all your devices is perfect enough, all the
534 0x02 ignore NVRAM "Synchronous negotiation" parameters for all devices
535 0x04 ignore NVRAM "Wide negotiation" parameter for all devices
536 0x08 ignore NVRAM "Scan at boot time" parameter for all devices
564 The driver just reads SCSI lines and checks all lines read FALSE except RESET.
701 used together with the Symbios cards using all their features, including
1001 2 - all