Lines Matching refs:control

42 This control is used to attenuate samples for left and right front PCM FX-bus
49 This control is used to attenuate samples for left and right surround PCM FX-bus
56 This control is used to attenuate samples for center PCM FX-bus accumulator.
62 This control is used to attenuate sample for LFE PCM FX-bus accumulator. 
68 This control is used to attenuate samples for left and right PCM FX-bus
75 This control is used to attenuate samples for left and right PCM FX-bus
82 This control is used to attenuate samples for left and right MIDI FX-bus
95 This control is used to attenuate samples for left and right Mic input.
98 capture FIFO (device 1 - 16bit/8KHz mono) too without volume control.
102 This control is used to attenuate samples for left and right Mic input.
108 This control is used to attenuate samples from left and right IEC958 TTL
114 This control is used to attenuate samples from left and right IEC958 TTL
120 This control is used to attenuate samples from left and right IEC958 optical
126 This control is used to attenuate samples from left and right IEC958 optical
132 This control is used to attenuate samples from left and right I2S ADC
138 This control is used to attenuate samples from left and right I2S ADC
144 This control is used to attenuate samples from left and right I2S ADC
151 This control is used to attenuate samples from left and right I2S ADC
157 This control is used to attenuate samples from left and right I2S ADC
163 This control is used to attenuate samples from left and right I2S ADC
170 This control is used to attenuate samples for left and right front speakers of
176 This control is used to attenuate samples for left and right surround speakers of
182 This control is used to attenuate sample for center speaker of this mix.
187 This control is used to attenuate sample for LFE speaker of this mix.
191 This control turns the tone control on or off. The samples for front, rear
196 This control sets the bass intensity. There is no neutral value!!
197 When the tone control code is activated, the samples are always modified.
202 This control sets the treble intensity. There is no neutral value!!
203 When the tone control code is activated, the samples are always modified.
208 This control is used to attenuate samples for front, surround, center and 
233 This control specifies the destination - FX-bus accumulators. There 24
342 …    US 6195715      Interrupt control for multiple programs communicating with      (Feb. 27, 2001)