Lines Matching refs:and

10   and "8ch".  According to the configuration, this also controls the
15   headphone and line-out jacks.  If built-in speakers and headphone
16   and/or line-out jacks are available on a machine, this controls
19   "Disabled" and "Enabled" state.  When enabled, the speaker is muted
22   When both headphone and line-out jacks are present, it gives
23   "Disabled", "Speaker Only" and "Line-Out+Speaker".  When
26   selected, plugging to a headphone jack mutes both speakers and
37   and the normal PCM playback are exclusive, i.e. when this is on, you
41   Swaps the center and LFE channel order.  Normally, the left
42   corresponds to the center and the right to the LFE.  When this is
43   ON, the left to the LFE and the right to the center.
48   and no HP-amp is set to the pins.
51   These enum controls the direction and the bias of the input jack
52   pins.  Depending on the jack type, it can set as "Mic In" and "Line 
62   When it's ON, the corresponding input jacks (usually a line-in and a
63   mic-in) are switched as the surround and the CLFE output jacks.
76   and speaker outputs.  As a side-effect, when this mode is set, the
78   headphones and speakers because there is only one DAC connected to a
109   It gives the number of channels to be used, "2ch", "4ch" and "6ch".