Lines Matching refs:via

53 read in two ways, either via a LPIB register or via a position-buffer
57 a case, you can change the default method via `position_fix` option.
77 via `bdl_pos_adj` option. 
102 It means that the codec response isn't notified via an IRQ.  The
111 codec slots via `probe_mask` option.  It's a bitmask, and each bit
240   external amplifier.  This can be set usually via EAPD verb or a
242   chance via SET_EAPD_BTL verb (0x70c).  On others, GPIO pin (mostly
263 When the PCM device is opened via "default" PCM (without pulse-audio
289 to fight against evil, try debugging via hitting the raw HD-audio
318 (one per each codec), and you have a raw access to the device via
422 them can be adjusted dynamically via "hints" strings as mentioned in
424 via sysfs or a patch file, you can disable the jack detection, thus
485 codec.  This can work basically like the reconfiguration via sysfs in
539 In the similar way, you can override the codec subsystem_id via
540 `[subsystem_id]`, the revision id via `[revision_id]` line.
541 Also, the codec chip name can be rewritten via `[chip_name]` line.
556 The hd-audio driver reads the file via request_firmware().  Thus,
575 turned off to save the power.  The time to go down is specified via
577 via sysfs.
607 via power-saving behavior.
633 a packed value, and you can decode it via hda-decode-verb program
663 is, installed via the usual spells: configure, make and make
724 configuration via hwdep sysfs file if hda-reconfig option is enabled.
765 via hda-verb won't change the mixer value.
804 parses the given codec proc file and converts to SVG via graphiz
857 it can be fixed either in the driver code statically or via passing a