Lines Matching refs:You

184   to install the driver sources. You should not try to install a separately
191   (see below). You need to do this only when installing sound driver
217 You are not running kernel which contains the sound driver. When using
288 - You get the famous "DMA timed out" messages. Usually all SB clones have
311 You should carefully check if "Plug & Play" or "PnP" is mentioned in the name
416 		You have been fooled since there are _no_ SB16 compatible
515 	are PnP chips and will not work with the OPL3-SA1 driver. You should 
554 	patch files to be installed on the system (in /dos/ultrasnd/midi). You
561 	some FTP sites). You should contact Voice Crystal (www.voicecrystal.com)
575 	NOTE! You will have to use the "old" config script when configuring
591         driver will not work with them. You may want to use OSS/Linux with these
603 	in the PnP mode. You will have to use them in MSS mode after having
636 	work fully in Linux. You can get audio features working by configuring
643 Some of the earliest sound cards were jumper configurable. You have to
658 You could usually use the same values than with DOS and/or Windows.
918 SB2_BASE, SB2_IRQ, SB2_DMA and SB2_DMA2 for the second one. You can't get
1000 IRQ and DMA numbers for the daughter card. You have to use different I/O
1059 program handles these options itself. (You may use the SB, MPU and MSS options
1069 With some cards the file is called 'synth.ld'. You must have access to
1079 You have to enable the OPL3 and SB (not SB Pro or SB16) drivers in addition
1087 in the proper address. The SB driver handles the rest. You have to configure
1094 where the DOS drivers were installed. You must have access to this file
1138 distributed in the snd-util-3.0.tar.gz package. You have to edit two
1139 defines in the ssinit.c and then compile the program. You may run ssinit 
1143 driver of the card. You will need to use version 1.30.00 or later
1177 You need to enable just the MAD16 /Mozart support when configuring
1214 fairly well. You have to enable SB, SB Pro (_not_ SB16) and MPU401 supports
1295 are compatible with SoundScape and some use the MAD16 chip. You may have
1348 mixer (input hears output signal). You can de-/activate this mode
1356 finished for the RDS decoder on this card, too. You will be able to
1374 You need to configure the driver with MSS and OPL3 supports enabled.