Lines Matching refs:radio

5 output, vbi capture and output, radio receivers and transmitters and a software
6 defined radio receiver. In addition a simple framebuffer device is available for
35 - Software defined radio (SDR) support
86 radio receiver device, one radio transmitter device and one SDR device.
172 radio_rx_nr: give the desired radioX start number for each radio receiver device.
175 radio_tx_nr: give the desired radioX start number for each radio transmitter
447 The radio receiver emulates an FM/AM/SW receiver. The FM band also supports RDS.
474 0B group, and also radio text and the current time.
483 The radio transmitter emulates an FM/AM/SW transmitter. The FM band also supports RDS.
561 The following controls are specific to video capture and output and radio
878 Since radio is wireless this looping always happens if the radio receiver
879 frequency is close to the radio transmitter frequency. In that case the radio
880 transmitter will 'override' the emulated radio stations.
939 As mentioned in section 6 the radio receiver emulates stations are regular
940 frequency intervals. Depending on the frequency of the radio receiver a
942 However, it will also look at the frequency set by the radio transmitter and
943 if that results in a higher signal strength than the settings of the radio
947 frequencies of the radio receiver and transmitter are not identical, so
1123 - The SDR radio should use the same 'frequencies' for stations as the normal
1124   radio receiver, and give back noise if the frequency doesn't match up with
1126 - Improve the sine generation of the SDR radio.