Lines Matching refs:DEBC_printk

319 #define DEBC_printk(t, fmt, a...) \  macro
322 #define DEBC_printk(t, fmt, a...) macro
684 DEBC_printk(STp, "Stepping over filemark %s.\n", in cross_eof()
722 DEBC_printk(STp, "Flushing %d bytes.\n", transfer); in st_flush_write_buffer()
866 DEBC_printk(STp, "%socking drive door.\n", do_lock ? "L" : "Unl"); in do_door_lock()
999 DEBC_printk(STp, "Mode change from %d to %d.\n", in check_tape()
1076 DEBC_printk(STp, "Can't read block limits.\n"); in check_tape()
1093 DEBC_printk(STp, "No Mode Sense.\n"); in check_tape()
1098 DEBC_printk(STp,"Mode sense. Length %d, " in check_tape()
1110 DEBC_printk(STp, "Density %x, tape length: %x, " in check_tape()
1137 DEBC_printk(STp, "Block size: %d, buffer size: %d (%d blocks).\n", in check_tape()
1144 DEBC_printk(STp, "Write protected\n"); in check_tape()
1158 DEBC_printk(STp, "Updating partition number in status.\n"); in check_tape()
1217 DEBC_printk(STp, "Device already in use.\n"); in st_open()
1306 DEBC_printk(STp, "switch_partition at close failed.\n"); in st_flush()
1322 DEBC_printk(STp, "Async write waits %d, finished %d.\n", in st_flush()
1364 DEBC_printk(STp, "Buffer flushed, %d EOF(s) written\n", cmd[4]); in st_flush()
1739 DEBC_printk(STp, "Error on write:\n"); in st_write()
1766 DEBC_printk(STp, "EOM with %d " in st_write()
1781 DEBC_printk(STp, "Retry " in st_write()
1795 DEBC_printk(STp, "EOM with " in st_write()
1906 DEBC_printk(STp, in read_tape()
1957 DEBC_printk(STp, "ILI but " in read_tape()
1977 DEBC_printk(STp, "EOF detected (%d " in read_tape()
1991 DEBC_printk(STp, "EOM detected (%d " in read_tape()
1998 DEBC_printk(STp, "Tape error while reading.\n"); in read_tape()
2002 DEBC_printk(STp, "Zero returned for " in read_tape()
2236 DEBC_printk(STp, "Initialized mode %d definition from mode 0\n",
2303 DEBC_printk(STp, "Default block size disabled.\n");
2306 DEBC_printk(STp,"Default block size set to "
2317 DEBC_printk(STp, "Long timeout set to %d seconds.\n",
2322 DEBC_printk(STp, "Normal timeout set to %d seconds.\n",
2343 DEBC_printk(STp,
2347 DEBC_printk(STp, "Density default set to %x\n",
2357 DEBC_printk(STp,
2361 DEBC_printk(STp,
2370 DEBC_printk(STp,
2375 DEBC_printk(STp, "Compression "
2381 DEBC_printk(STp, "Compression default "
2505 DEBC_printk(STp, "Compression mode page not supported.\n"); in st_compression()
2510 DEBC_printk(STp, "Compression state is %d.\n", in st_compression()
2515 DEBC_printk(STp, "Compression not supported.\n"); in st_compression()
2533 DEBC_printk(STp, "Compression change failed.\n"); in st_compression()
2536 DEBC_printk(STp, "Compression state changed to %d.\n", state); in st_compression()
2567 DEBC_printk(STp, " Enhanced %sload slot %2d.\n", in do_load_unload()
2784 DEBC_printk(STp, "Rewinding tape.\n"); in st_int_ioctl()
2788 DEBC_printk(STp, "No op on tape.\n"); in st_int_ioctl()
2798 DEBC_printk(STp, "Retensioning tape.\n"); in st_int_ioctl()
2816 DEBC_printk(STp, "Spacing to end of recorded medium.\n"); in st_int_ioctl()
2832 DEBC_printk(STp, "Erasing tape.\n"); in st_int_ioctl()
3074 DEBC_printk(STp, " Can't read tape position.\n"); in get_location()
3093 DEBC_printk(STp, "Got tape pos. blk %d part %d.\n", in get_location()
3120 DEBC_printk(STp, "Setting block to %d and partition to %d.\n", in set_location()
3135 DEBC_printk(STp, "Visited block %d for " in set_location()
3159 DEBC_printk(STp, "Trying to change partition " in set_location()
3259 DEBC_printk(STp, "Can't read medium partition page.\n"); in nbr_partitions()
3264 DEBC_printk(STp, "Number of partitions %d.\n", result); in nbr_partitions()
3298 DEBC_printk(STp, "Can't read partition mode page.\n"); in partition_tape()
3304 DEBC_printk(STp, "Partition page length is %d bytes.\n", in partition_tape()
3315 DEBC_printk(STp, "psd_cnt %d, max.parts %d, nbr_parts %d\n", in partition_tape()
3323 DEBC_printk(STp, "Formatting tape with one partition.\n"); in partition_tape()
3330 DEBC_printk(STp, "Formatting tape with two partitions " in partition_tape()