213 	snd_printk(KERN_ERR LOGNAME ": Cannot reset DSP\n");  in snd_msnd_reset_dsp()
229 		snd_printk(KERN_ERR LOGNAME ": I/O port conflict\n");  in snd_msnd_probe()
393 		printk(KERN_ERR LOGNAME ": Error loading " INITCODEFILE);  in upload_dsp_code()
398 		printk(KERN_ERR LOGNAME ": Error loading " PERMCODEFILE);  in upload_dsp_code()
460 			snd_printd(KERN_ERR LOGNAME ": DSP reset timeout\n");  in snd_msnd_initialize()
551 		printk(KERN_ERR LOGNAME ": Couldn't grab IRQ %d\n", chip->irq);  in snd_msnd_attach()
560 		printk(KERN_ERR LOGNAME  in snd_msnd_attach()
569 		printk(KERN_ERR LOGNAME  in snd_msnd_attach()
587 		printk(KERN_ERR LOGNAME ": error creating new PCM device\n");  in snd_msnd_attach()
593 		printk(KERN_ERR LOGNAME ": error creating new Mixer device\n");  in snd_msnd_attach()
608 			printk(KERN_ERR LOGNAME  in snd_msnd_attach()
658 		printk(KERN_ERR LOGNAME ": snd_msnd_write_cfg: I/O error\n");  in snd_msnd_write_cfg()
841 		printk(KERN_ERR LOGNAME ": \"io\" - DSP I/O base must be set "  in snd_msnd_isa_match()
848 		printk(KERN_ERR LOGNAME  in snd_msnd_isa_match()
861 		printk(KERN_ERR LOGNAME  in snd_msnd_isa_match()
872 		printk(KERN_ERR LOGNAME ": \"mem\" - must be set to "  in snd_msnd_isa_match()
950 		printk(KERN_ERR LOGNAME ": Config port 0x%lx conflict\n",  in snd_msnd_isa_probe()
1041 		printk(KERN_ERR LOGNAME ": Probe failed\n");  in snd_msnd_isa_probe()
1048 		printk(KERN_ERR LOGNAME ": Attach failed\n");  in snd_msnd_isa_probe()
1166 		printk(KERN_ERR LOGNAME ": Probe failed\n");  in snd_msnd_pnp_detect()
1172 		printk(KERN_ERR LOGNAME ": Attach failed\n");  in snd_msnd_pnp_detect()