Lines Matching refs:temperature

49 The chips support up to 25 temperature monitoring sources. Up to 6 of those are
50 direct temperature sensor inputs, the others are special sources such as PECI,
51 PCH, and SMBUS. Depending on the chip type, 2 to 6 of the temperature sources
58 The temperature sensor sources on all chips are configurable. The configured
59 source for each of the temperature sensors is provided in tempX_label.
62 either 1 degC or 0.5 degC, depending on the temperature source and
63 configuration. An alarm is triggered when the temperature gets higher than
64 the high limit; it stays on until the temperature falls below the hysteresis
82 In this mode, the chip attempts to keep the measured temperature in a
83 predefined temperature range. If the temperature goes out of range, fan
94 pwm[1-5]_enable - this file controls mode of fan/temperature control:
109 pwm[1-5]_temp_sel	Temperature source. Value is temperature sensor index.
112 			Secondary temperature source. Value is temperature
114 			Set to 0 to disable secondary temperature control.
116 If secondary temperature functionality is enabled, it is controlled with the
126 			Temperature at which secondary temperature control kicks
134 If the temperature is in the range defined by:
136 pwm[1-5]_target_temp	Target temperature, unit millidegree Celsius
139 			Target temperature tolerance, unit millidegree Celsius
141 there are no changes to fan speed. Once the temperature leaves the interval, fan
142 speed increases (if temperature is higher that desired) or decreases (if
143 temperature is lower than desired), using the following limits and time
147 			when the temperature is above defined range.
148 pwm[1-5]_floor		lowest fan pwm (range 0 - 255) if temperature is below
150 			stop if the temperature is below the defined range.
154 			corresponding fan off (when the temperature was below
173 controlled by setting the pwm and temperature attributes. When the temperature
177 higher fan speeds with increasing temperature. The last data point reflects
178 critical temperature mode, in which the fans should run at full speed.
181 			pwm value to be set if temperature reaches matching
182 			temperature range.
188 			Temperature tolerance for critical temperature,
199 temperature measurement device. As a result, the temperature reported on CPUTIN
201 temperatures, and in some cases the reported temperature declines if the actual
202 temperature increases (similar to the raw PECI temperature value - see PECI
204 boards. The CPU temperature on ASUS boards is reported from PECI 0.