| /linux-4.1.27/drivers/mtd/spi-nor/ |
| D | Kconfig | 16 to erasing whole blocks (32/64 KiB).
19 64 KiB block instead of 16 × 4 KiB sectors.
22 4096 B erase size (e.g. UBIFS requires 15 KiB as a minimum).
|
| /linux-4.1.27/Documentation/arm/ |
| D | tcm.txt | 6 This is usually just a few (4-64) KiB of RAM inside the ARM
13 The size of DTCM or ITCM is minimum 4KiB so the typical
14 minimum configuration is 4KiB ITCM and 4KiB DTCM.
40 on, supporting a maximum of 32KiB of ITCM and 32KiB of DTCM.
43 TCMs in two separate banks, so for example an 8KiB ITCM is divided
44 into two 4KiB banks with its own control registers. The idea is to
|
| D | Booting | 114 it. The recommended placement is in the first 16KiB of RAM.
|
| /linux-4.1.27/Documentation/ABI/stable/ |
| D | sysfs-devices-system-xen_memory | 54 As target above, except the value is in KiB.
61 Current size (in KiB) of this domain's memory
69 Amount (in KiB) of high memory in the balloon.
76 Amount (in KiB) of low (or normal) memory in the
|
| /linux-4.1.27/Documentation/arm/Samsung-S3C24XX/ |
| D | NAND.txt | 17 The driver is capable of handling NAND flash with a 2KiB page
21 each 256 byte block in an 2KiB page. This means that more than
|
| D | Suspend.txt | 126 `S3C2410 PM Suspend CRC Chunksize (KiB)`
|
| /linux-4.1.27/drivers/mtd/onenand/ |
| D | Kconfig | 60 of 4KiB. Plane1 has only even blocks such as block0, block2, block4
62 So MTD regards it as 4KiB page size and 256KiB block size
|
| /linux-4.1.27/Documentation/zh_CN/arm/ |
| D | Booting | 120 建议放在 RAM 的头 16KiB 中。
132 dtb 必须置于内核自解压不会覆盖的内存区。建议将其放置于 RAM 的头 16KiB
|
| /linux-4.1.27/Documentation/filesystems/nfs/ |
| D | rpc-server-gss.txt | 52 A) It can handle tokens that are no bigger than 2KiB
55 beyond 64KiB in size due to various authorization extensions attacked to
62 back to the kernel (4KiB).
|
| /linux-4.1.27/Documentation/devicetree/bindings/misc/ |
| D | brcm,kona-smc.txt | 14 reg = <0x3404c000 0x400>; //1 KiB in SRAM
|
| D | sram.txt | 41 reg = <0x5c000000 0x40000>; /* 256 KiB SRAM at address 0x5c000000 */
|
| /linux-4.1.27/Documentation/mtd/nand/ |
| D | pxa3xx-nand.txt | 12 larger pages, I/O operations on 4 KiB and 8 KiB pages is done with a set of
23 buffer with this layout (in the 4 KiB page case):
|
| /linux-4.1.27/drivers/mtd/ |
| D | ssfdc.c | 45 #define KiB(x) ( (x) * 1024L ) macro
46 #define MiB(x) ( KiB(x) * 1024L )
|
| /linux-4.1.27/Documentation/virtual/kvm/devices/ |
| D | mpic.txt | 16 Base address of the 256 KiB MPIC register space. Must be
|
| /linux-4.1.27/drivers/mmc/card/ |
| D | Kconfig | 48 a big performance gain at the cost of up to 64 KiB of
|
| /linux-4.1.27/Documentation/filesystems/ |
| D | jfs.txt | 47 64 blocks, which means 256KiB in JFS.
|
| D | squashfs.txt | 30 Max block size: 1 MiB 4 KiB
173 is split into slots, caching up to eight 224 GiB files (128 KiB blocks).
176 16 KiB.
|
| D | xfs.txt | 26 doing delayed allocation writeout (default size is 64KiB).
27 Valid values for this option are page size (typically 4KiB)
|
| D | ubifs.txt | 16 rather large size, typically about 128KiB. Block devices consist of
|
| /linux-4.1.27/Documentation/devicetree/bindings/soc/fsl/ |
| D | bman.txt | 81 - The size must be 2^(size + 1), with size = 11..33. That is 4 KiB to
|
| D | qman.txt | 98 - The size must be 2^(size + 1), with size = 11..29. That is 4 KiB to
|
| /linux-4.1.27/drivers/mtd/devices/ |
| D | Kconfig | 155 int "MTDRAM device size in KiB"
165 int "MTDRAM erase block size in KiB"
|
| /linux-4.1.27/Documentation/ |
| D | ldm.txt | 59 hda: 102400 sectors w/32KiB Cache, CHS=50/64/32
|
| D | DMA-ISA-LPC.txt | 38 or 128 KiB depending on which channel you use).
|
| D | xz.txt | 78 xz --check=crc32 --lzma2=dict=512KiB inputfile
|
| /linux-4.1.27/lib/ |
| D | Kconfig | 131 This is the fastest algorithm, but comes with a 8KiB lookup table.
142 This is a bit slower than slice by 8, but has a smaller 4KiB lookup
|
| /linux-4.1.27/arch/powerpc/platforms/ps3/ |
| D | Kconfig | 137 As this driver needs a fixed buffer of 256 KiB of memory, it can
|
| /linux-4.1.27/arch/arm/boot/dts/ |
| D | bcm21664.dtsi | 60 reg = <0x3404e000 0x400>; /* 1 KiB in SRAM */
|
| D | bcm11351.dtsi | 60 reg = <0x3404c000 0x400>; /* 1 KiB in SRAM */
|
| D | am437x-idk-evm.dts | 343 * MTD partition table. The ROM checks the first 512KiB for a
|
| D | dra72-evm.dts | 526 * 64KiB block size.
|
| D | dra7-evm.dts | 499 * 64KiB block size.
|
| D | am437x-sk-evm.dts | 577 * The ROM checks the first 512KiB
|
| D | am43x-epos-evm.dts | 619 * The ROM checks the first 512KiB
|
| D | tegra124.dtsi | 38 0x81000000 0 0x0 0x0 0x12000000 0 0x00010000 /* downstream I/O (64 KiB) */
|
| /linux-4.1.27/arch/arm/plat-samsung/ |
| D | Kconfig | 289 int "S3C2410 PM Suspend CRC Chunksize (KiB)"
|
| /linux-4.1.27/Documentation/devicetree/bindings/powerpc/fsl/ |
| D | interlaken-lac.txt | 30 There are two 4KiB spaces defined within the LAC global register memory map.
|
| /linux-4.1.27/drivers/staging/comedi/ |
| D | Kconfig | 17 int "Comedi default initial asynchronous buffer size in KiB"
22 defaults to 2048 KiB of memory so that a 16 channel card
26 int "Comedi default maximum asynchronous buffer size in KiB"
31 This is set to 20480 KiB so that a fast I/O card with 16
|
| /linux-4.1.27/Documentation/usb/ |
| D | mass-storage.txt | 225 transport mode and 16 KiB buffers.
|
| /linux-4.1.27/drivers/base/ |
| D | Kconfig | 320 For example, if your system defaults to 4KiB pages, the order value
|
| /linux-4.1.27/drivers/mtd/nand/ |
| D | Kconfig | 296 first five erase blocks (256KiB each) are write-protected, followed
|
| /linux-4.1.27/arch/arm/mm/ |
| D | Kconfig | 242 based upon the ARM10 integer core with a 16KiB L1 Harvard cache,
|
| /linux-4.1.27/drivers/platform/x86/ |
| D | Kconfig | 746 to prohibit certain system agents from accessing memory with 1 KiB
|
| /linux-4.1.27/arch/arm/ |
| D | Kconfig | 1820 entire decompressed kernel plus an additional 128 KiB.
|
| /linux-4.1.27/init/ |
| D | Kconfig | 1432 size (depending on the kernel configuration, it may be 300KiB or
|