| /linux-4.1.27/Documentation/sound/alsa/ |
| D | Channel-Mapping-API.txt | 16 { front left, front right, rear left, rear right }.
22 from rear. Or, some devices secretly assume that center/LFE is the
85 SNDRV_CHMAP_RL, /* rear left */
86 SNDRV_CHMAP_RR, /* rear right */
91 SNDRV_CHMAP_RC, /* rear center */
95 SNDRV_CHMAP_RLC, /* rear left center */
96 SNDRV_CHMAP_RRC, /* rear right center */
106 SNDRV_CHMAP_TRL, /* top rear left */
107 SNDRV_CHMAP_TRR, /* top rear right */
108 SNDRV_CHMAP_TRC, /* top rear center */
|
| D | CMIPCI.txt | 11 channels can be used for front/rear playbacks. Since there are two
17 (hw:0,1) is assigned to the second DAC for rear playback.
29 The rear output can be heard only when "Four Channel Mode" switch is
30 disabled. Otherwise no signal will be routed to the rear speakers.
34 When "Four Channel Mode" switch is off, the output from rear speakers
43 from front and rear speakers! But.. after reboot, all was gone.
47 If your card has an extra output jack for the rear output, the rear
51 is used as rear output.
53 There are two more controls regarding to the rear output.
54 The "Exchange DAC" switch is used to exchange front and rear playback
|
| D | SB-Live-mixer.txt | 65 The result samples are forwarded to the rear I2S DACs. These DACs operates
73 the ??rear?? right DAC PCM slot of the AC97 codec.
80 the ??rear?? left DAC PCM slot of the AC97 codec.
106 This control is used to attenuate samples for left and right rear PCM FX-bus
107 accumulators. ALSA uses accumulators 2 and 3 for left and right rear PCM samples.
108 The result samples are forwarded to the rear I2S DACs. These DACs operate
114 These controls are used to attenuate samples for left and right rear PCM FX-bus
115 accumulators. ALSA uses accumulators 2 and 3 for left and right rear PCM samples.
123 to the ??rear?? right DAC PCM slot of the AC97 codec.
129 to the ??rear?? left DAC PCM slot of the AC97 codec.
[all …]
|
| D | ControlNames.txt | 20 Surround (rear left/right in 4.0/5.1 surround)
|
| D | Audigy-mixer.txt | 191 This control turns the tone control on or off. The samples for front, rear
|
| D | ALSA-Configuration.txt | 2102 rear_switch - enable shared rear/line-in switch (bool)
|
| /linux-4.1.27/drivers/staging/comedi/drivers/ |
| D | dt3000.c | 301 int rear; in dt3k_ai_empty_fifo() local
311 rear = devpriv->ai_rear; in dt3k_ai_empty_fifo()
314 data = readw(dev->mmio + DPR_ADC_buffer + rear); in dt3k_ai_empty_fifo()
316 rear++; in dt3k_ai_empty_fifo()
317 if (rear >= AI_FIFO_DEPTH) in dt3k_ai_empty_fifo()
318 rear = 0; in dt3k_ai_empty_fifo()
321 devpriv->ai_rear = rear; in dt3k_ai_empty_fifo()
322 writew(rear, dev->mmio + DPR_AD_Buf_Rear); in dt3k_ai_empty_fifo()
|
| /linux-4.1.27/arch/microblaze/kernel/ |
| D | entry-nommu.S | 103 mfs r11, rear
161 mts rear, r11
263 mfs r11, rear
354 mfs r11, rear
421 mfs r12, rear
441 mts rear, r12
536 mts rear, r18
|
| D | entry.S | 524 mfs r4, rear /* EAR */
553 mfs r6, rear /* parameter unsigned long address */
565 mfs r6, rear /* parameter unsigned long address */
774 mfs r11, rear;
906 mfs r12, rear
|
| D | hw_exception_handler.S | 353 mfs r3, rear;
|
| /linux-4.1.27/sound/oss/dmasound/ |
| D | dmasound_core.c | 533 sq->rear = -1; in sq_setup()
609 dest = write_sq.buffers[write_sq.rear]; in sq_write()
650 dest = write_sq.buffers[(write_sq.rear+1) % write_sq.max_count]; in sq_write()
661 write_sq.rear = (write_sq.rear+1) % write_sq.max_count; in sq_write()
828 write_sq.rear = -1 ; /* same as for set-up */ in sq_reset_output()
1330 write_sq.max_active, write_sq.front, write_sq.rear, in state_open()
|
| D | dmasound.h | 226 int front, rear, count; member
|
| /linux-4.1.27/arch/arm/boot/dts/ |
| D | stih410-pinctrl.dtsi | 13 pin-controller-rear {
|
| D | armada-xp-netgear-rn2120.dts | 91 /* Two rear eSATA ports */
139 /* Controller for rear fan #1 of 3 (Protechnic
150 /* Controller for rear (center) fan #2 of 3 */
160 /* Controller for rear fan #3 of 3 */
|
| D | stih415.dtsi | 52 syscfg_rear: rear-syscfg@fe830000{
53 compatible = "st,stih415-rear-syscfg", "syscon";
|
| D | stih407-family.dtsi | 91 syscfg_rear: rear-syscfg@9290000 {
92 compatible = "st,stih407-rear-syscfg", "syscon";
|
| D | armada-370-synology-ds213j.dts | 175 /* rear USB port, near reset button */
180 /* rear USB port, near RJ45 port */
|
| D | stih416.dtsi | 53 syscfg_rear:rear-syscfg@fe830000{
54 compatible = "st,stih416-rear-syscfg", "syscon";
|
| D | stih407-pinctrl.dtsi | 464 pin-controller-rear {
467 compatible = "st,stih407-rear-pinctrl";
|
| D | stih415-pinctrl.dtsi | 293 pin-controller-rear {
296 compatible = "st,stih415-rear-pinctrl";
|
| D | stih416-pinctrl.dtsi | 363 pin-controller-rear {
366 compatible = "st,stih416-rear-pinctrl";
|
| D | armada-xp-synology-ds414.dts | 96 * providing the two rear USB 3.0 ports.
|
| /linux-4.1.27/kernel/locking/ |
| D | lockdep.c | 907 unsigned int front, rear; member
918 cq->front = cq->rear = 0; in __cq_init()
924 return (cq->front == cq->rear); in __cq_empty()
929 return ((cq->rear + 1) & CQ_MASK) == cq->front; in __cq_full()
937 cq->element[cq->rear] = elem; in __cq_enqueue()
938 cq->rear = (cq->rear + 1) & CQ_MASK; in __cq_enqueue()
954 return (cq->rear - cq->front) & CQ_MASK; in __cq_get_elem_count()
|
| /linux-4.1.27/sound/firewire/ |
| D | Kconfig | 49 Say Y here to include support for the front and rear microphones
|
| /linux-4.1.27/Documentation/input/ |
| D | joystick.txt | 258 rear side of the joystick. However, moving it, you'll reset the joystick,
|
| /linux-4.1.27/Documentation/networking/ |
| D | arcnet-hardware.txt | 715 Two diagnostic LEDs are visible on the rear bracket of the board.
942 Two diagnostic LEDs are visible on the rear bracket of the board.
|