Searched refs:settling (Results 1 – 19 of 19) sorted by relevance
| /linux-4.4.14/Documentation/devicetree/bindings/input/touchscreen/ |
| D | stmpe.txt | 20 - st,settling: Panel driver settling time (0 -> 10 us, 1 -> 100 us, 2 -> 500 us, 3
40 st,settling = <2>;
|
| D | brcm,iproc-touchscreen.txt | 14 - settling_timeout: The settling duration (in ms) is the amount of time
|
| D | ti-tsc-adc.txt | 42 hardware knob for adjusting the amount of "settling
|
| /linux-4.4.14/Documentation/devicetree/bindings/staging/iio/adc/ |
| D | mxs-lradc.txt | 19 - fsl,settling: delay between plate switch to next sample. Allowed value is
33 fsl,settling = <10>;
46 fsl,settling = <10>;
|
| /linux-4.4.14/Documentation/devicetree/bindings/regulator/ |
| D | ti-abb-regulator.txt | 20 - ti,settling-time: Settling time in uSecs from SoC documentation for ABB module
23 computing settling time from SoC Documentation for ABB module(clock
78 ti,settling-time = <30>;
98 ti,settling-time = <50>;
125 ti,settling-time = <50>;
|
| /linux-4.4.14/drivers/input/touchscreen/ |
| D | stmpe-ts.c | 77 u8 settling; member
204 SETTLING(ts->settling); in stmpe_init_hw()
287 ts->settling = val; in stmpe_ts_get_platform_info()
|
| /linux-4.4.14/drivers/staging/iio/Documentation/ |
| D | sysfs-bus-iio-impedance-analyzer-ad5933 | 27 Number of output excitation cycles (settling time cycles)
|
| /linux-4.4.14/arch/arm/boot/dts/ |
| D | omap36xx.dtsi | 53 ti,settling-time = <30>;
|
| D | imx53-m53.dtsi | 74 st,settling = <4>;
|
| D | tegra30-colibri.dtsi | 356 /* 1 ms panel driver settling time */
357 st,settling = <3>;
|
| D | spear320-hmi.dts | 267 ts,settling = <4>;
|
| D | tegra30-apalis.dtsi | 590 /* 1 ms panel driver settling time */
591 st,settling = <3>;
|
| D | imx28-evk.dts | 189 fsl,settling = <10>;
|
| D | spear1310-evb.dts | 382 ts,settling = <2>;
|
| D | dra7.dtsi | 965 ti,settling-time = <50>;
998 ti,settling-time = <50>;
1031 ti,settling-time = <50>;
1064 ti,settling-time = <50>;
|
| D | spear1340-evb.dts | 493 ts,settling = <2>;
|
| D | omap4.dtsi | 911 ti,settling-time = <50>;
924 ti,settling-time = <50>;
|
| D | omap5.dtsi | 1085 ti,settling-time = <50>;
1115 ti,settling-time = <50>;
|
| /linux-4.4.14/drivers/block/ |
| D | swim3.c | 51 settling, enumerator
540 case settling: in act()
734 fs->state = settling; in swim3_interrupt()
738 case settling: in swim3_interrupt()
|